2023_11_28

1 Lunch ride lunch ride.	2 This is not the side to remove the axle.	3 This is the side to remove the axle. No torque specs here? 15Nm says the manual.	4	5 Now we loosen up the cable ports so the cables can move a bit.	6 Remove the first bolt from inside the collet.
7 Remove collet. They like collets on this bike.	8	9 End to end the cables must be unrestrained.	10 Now we can lift the triangle up and out of the way and have it stay there.	11 Thought there might be a dust cap over that bearing	12 Easy to move it up and down to get clear access to clean the posts.
13	14 Clean the grease ports.	15 Grease in the tube will go into the pump.	16 Really had to squeeze the tube to prime it.	17 Squeeze (firmly!) to press the grease in, until it starts erupting out. Check.	18 We see you, grease.
19 Torque wrench to reassemble.	20	21 Dust and wear marks sort of show where cables should be.	22 All snugged back up over here.	23 All good over here. That holder is more complex on the other side.