  1 Had to dig behind some stuff in the garage to find this. Garage needs a bit of a purge! |
 2 Reduced width bed platform support rail looks good. |
 3 Measure the iron bar backstop plate to fit the new size. |
 4 The other side shows how far we want. |
 5 Affix this board out here where it is easy. |
 6 That front strip with continuous velcro is going to go. The bar that matched it already came out. |
 7 One cut done. Not bad. |
 8 Next. |
 9 Marked it up while still installed. Easy. |
 10 Done with the circular saw. |
 11 Each rail has a distinctive pattern to match one line of velcro. |
 12 Installed and ready for the bars. |
 13 We will call this the #1 bar. |
 14 Four bars now instead of five. 50" of board now instead of 60". |
 15 S M R T of me to put witness marks on the rail and platform before I took the boards off. |
 16 Circular saw is a bit messy along the edges. Hand-dressing removes anything that will snag linens. |
 17 Not as much space to move stuff in and out here. |
 18 Re-secured. Ready for foam and linens. |
